ValueRAM's KVR1066D3N7K3/3G is a triple-channel kit consisting of three 128M x 64-bit 1GB (1024MB) DDR3- 1066 CL7 SDRAM (Synchronous DRAM) memory modules, based on eight 128M x 8-bit DDR3-1066 FBGA components per module. Total kit capacity is 3GB (3072MB). The SPDs are programmed to JEDEC standard latency 1066Mhz timing of 7-7-7 at 1.5V. Each 240-pin DIMM uses gold contact fingers and requires +1.5V.

JEDEC standard 1.5V ± 0.075V Power Supply

VDDQ = 1.5V ± 0.075V

533MHz fCK for 1066Mb/sec/pin

8 independent internal bank

Programmable CAS Latency: 6,7,8,9

Posted CAS

Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

Programmable CAS Write Latency(CWL) = 7(DDR3-1066)

8-bit pre-fetch

Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]

Bi-directional Differential Data Strobe

Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)

On Die Termination using ODT pin

Average Refresh Period 7.8us at lower then TCASE 85°C, 3.9us at 85°C < TCASE . 95°C

Asynchronous Reset

PCB : Height 1.180 inch (30.00mm), single sided component